The effect of placing a grid over the outlet of the three-dimensional turbulent wall jet
Loading...
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
University of New Brunswick
DOI
Abstract
The three-dimensional turbulent wall jet has a lateral half-width that is 5 to 8 times
greater than its vertical half-height. This has been previously attributed to strong
turbulence generated secondary flow caused by the passage of coherent vortex-ring
structures formed at the nozzle exit. In order to assess whether the large lateral growth
of the jet is tied to these structures, a grid was placed at the nozzle exit to disrupt the
shear-layer that produces the vortex rings at the outlet. Here, the jet was formed using a
0.038m round contoured nozzle with an exit Reynolds number of 108,000. The grid has
a mesh wire size of 0.2mm with an opening of 1mm giving it a solidity ratio of 0.4.
Measurements of the jet with and without the grid were taken using hot-wire
anemometry and stereoscopic Particle Image Velocimetry (PIV). The results indicate
that the grid delays the lateral growth of the jet and increases its vertical growth. By
x/0=40 though, these differences were minimal. The presence of the grid also decreased
the mass entrainment and mixing associated with the jet at each downstream location
investigated.
Description
Keywords
Citation
Collections
Endorsement
Review
Supplemented By
Referenced By
Rights and licensing
http://purl.org/coar/access_right/c_abf2
